VLAN Tagging on WAN Port - Archer C1200
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Hello,
I have been using Archer C1200 for a few years and working properly.
I am planning to change ISP next month and I do not want to use the ISP-provided router.
I've been told that any router can be used on this ISP's network as long as it is capable of enabling VLAN tagging for ID 6 on the WAN port (the internet service is DHCP).
Is it possible for the Archer C1200 to do the above so I can continue using it?
I know about the IPTV/VLAN section available in the Advanced/network menu, but I am understood it actually refers to tag only LAN1 to 4 ports but not the WAN port...
Can someone confirm ?
Thanks,
Loic
Hi, in the IPTV/VLAN section, you could change Mode from Bridge to your ISP(If it is listed) or Custom, then you will be able to set Internet VLAN ID, which is for WAN.
Hi, in the IPTV/VLAN section, you could change Mode from Bridge to your ISP(If it is listed) or Custom, then you will be able to set Internet VLAN ID, which is for WAN.