Home Network Community > All Threads > How to limit backhaul frequencies?
< All Threads

How to limit backhaul frequencies?

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

How to limit backhaul frequencies?

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
How to limit backhaul frequencies?
How to limit backhaul frequencies?
2024-01-25 20:43:40
Tags: #Bandwidth Control/QoS #Connection Preference #WIFI backhaul
Model: Deco M5  
Hardware Version: V2
Firmware Version: 1.7.1

My Deco M5 mesh interferes with a 3rd party local 2,4 GHz connection (not wi-fi).
Deco is set to use 'only 5 Ghz', and I have run the interference tool in the Deco app, but still creates intermittent noise in the 2,4 GHz band while Deco is switched on.

 

Can I limit the backhaul to not use the 2,4 GHz band?

 

Thanks

Jorgen

  0      
 
  0      
 
#1
Options
2 Reply
Re:How to limit backhaul frequencies?
2024-01-26 09:34:03

  @jbsvendsen 

Hi, welcome to the community.

May I know what is this "3rd party local 2,4 GHz connection (not wi-fi)"?

Are you able to connect Deco units via Ethernet cables?

Currently, the 2.4GHz wireless Backhaul can not be disabled.

Thank you very much and best regards.

▶Check What's Currently Going on With Deco ▶Deco Starts Supporting Changing Wireless Channels! Deco BE85_1.1.1 Supports WireGuard VPN,Channel Selection and Matter Deco BE65_V2_1.1.0 Supports WireGuard VPN, Channel Selection and More ▶Deco APP 3.8.102/3.8.112-Ready for A New Deco Onboarding Experience! Try to leave a Message if urgent help is required.
  0  
  0  
#2
Options
Re:How to limit backhaul frequencies?
2024-01-29 15:50:37

  @David-TP 

 

Thank you David!

 

The 3rd party device is a Sony Bravia KDL-40EX1 digital TV consisting of a TV screen and media box connected through a wireless connection.

I was wrong about the bandwidth, according to the manual the TV uses OFDM wireless transmission on the 5.15 to 5.25 GHz range.

I have now changed the Deco to provide 2.4 GHz WLAN only, but the problem is still there.

 

So I should rephrase the question: Is it possible to disable the 5 GHz band in the Backhaul?

 

Unfortunately it is physically impossible to rearrange mesh routers or to connect them with Ethernet cables.

Any other ideas?

 

Many thanks

Jorgen

  0  
  0  
#3
Options

Information

Helpful: 0

Views: 357

Replies: 2

Tags

Bandwidth Control/QoS Connection Preference
WIFI backhaul
Related Articles
Channel frequencies
411 0
Limit speed ?
1507 0
Easymesh and frequencies
518 0
Change 4G Frequencies
502 0
Powerline Backhaul - Inverted Connection
118 0
Archer AX11000 WiFi frequencies and Virtual Servers
393 0
About Us
Press
Copyright © TP-Link Systems Inc. All rights reserved.