Get Device to Stay on 2.4GHz Band?
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
I have a Deco X20 mesh system. The logger on my solar PV system will only work on the 2.4GHz band. It often goes offline in its app and, checking, it tells me that it's connected to the 5GHz band, which it can't use. So, how do I get it to stay on the Deco's 2.4GHz band?
TIA,
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
Depending on X20 hardware and firmware versions, there may be options that would allow to force your solar PV system use 2.4GHz band.
If your Deco set does not have these features/options, there is a workaround.
Options:
1. Check if your Deco mesh has IoT network capability: What is an IoT Network?
If it does, enable and configure IoT network, make it run on 2.4GHz only, make your solar PV system connect to IoT Network SSID.
2. Check if your Deco mesh allows to configure Connection Preference, see Part 2 of the following FAQ: How to select a preferred signal source on the Deco App
If yes, using this feature configure 2.4GHz as a preferred band for your solar PV system.
Workaround:
If none of the above, the workaround would be to enable Guest Network, configure it to run on 2.4GHz only (disable 5GHz for it) and make your solar PV system connect to Guest Network SSID.
- Copy Link
- Report Inappropriate Content
Depending on X20 hardware and firmware versions, there may be options that would allow to force your solar PV system use 2.4GHz band.
If your Deco set does not have these features/options, there is a workaround.
Options:
1. Check if your Deco mesh has IoT network capability: What is an IoT Network?
If it does, enable and configure IoT network, make it run on 2.4GHz only, make your solar PV system connect to IoT Network SSID.
2. Check if your Deco mesh allows to configure Connection Preference, see Part 2 of the following FAQ: How to select a preferred signal source on the Deco App
If yes, using this feature configure 2.4GHz as a preferred band for your solar PV system.
Workaround:
If none of the above, the workaround would be to enable Guest Network, configure it to run on 2.4GHz only (disable 5GHz for it) and make your solar PV system connect to Guest Network SSID.
- Copy Link
- Report Inappropriate Content
@Alexandre. Thanks! I'll have a look at this tomorrow...
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 435
Replies: 2
Voters 0
No one has voted for it yet.