Home Network Community > All Threads > IPsec-VPN autostart
< All Threads

IPsec-VPN autostart

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

IPsec-VPN autostart

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
IPsec-VPN autostart
IPsec-VPN autostart
2023-07-27 13:21:15
Tags: #VPN
Model: TL-MR6400  
Hardware Version: V5
Firmware Version: 1.4.0 0.9.1 Build 220506

Hi folks,

I'm using an MR-6400 V5.3 and was wondering if someone has stumbled upon the same problem: when the router is rebooted the IPsec-Connection does not automatically reconnect, you have to enter the gui and disable/enable the connection to go up. In a branchoffice this is a big problem after a power-failure.
Is there any chance of changing this behaviour?

kind regards,

Wolfgang

 

  0      
 
  0      
 
#1
Options
2 Reply
Re:IPsec-VPN autostart
2023-07-28 07:48:35

  @Woppy 

 

Hi, please try to enable Dead Peer Detection on Advanced->VPN->IPSec VPN to see if it solves the problem.

Nice to Meet You in Our TP-Link Community. Check Out the Latest Posts: Archer GE550 - BE9300 Tri-Band Wi-Fi 7 Gaming Router EasyMesh Is Available When Wi-Fi Routers Work in AP Mode as A Controller. Archer BE550 New Software Enhances System Stability and Optimizes MLO Network Stability. TL-WA3001 Supports EasyMesh, Speed Limit, Guest Network in AP Mode and/or Multi-SSID Mode. If you found the post or response helpful, please click Helpful. If an answer solves your problem, click "Recommended Solution" so that others can benefit from it.
  0  
  0  
#2
Options
Re:IPsec-VPN autostart
2023-07-28 08:37:05

  @Sunshine 

Unfortunately that didnt help. But i dug a little deeper: this 6400 connects to a Fortigate VM as IPsec-Server, i watched the log while the 6400 booted and saw the tunnel come up for a second or two, a ping to the remote network worked twice, then failed again. Fortigate does not show tunnel going down, the 6400 says "down". So i'm afraid this behaviour occurs in this special combination 6400/Fortigate.
After disabling/enabling the tunnel on the 6400-side it comes up fine and stays up. Maybe something going to quick during startup.. who knows.
I guess i'll have to live with that.

But thanks anyways for the hint!

 

  0  
  0  
#3
Options

Information

Helpful: 0

Views: 520

Replies: 2

Tags

VPN
Related Articles
TL-MR6400 V5.3 is unable to establish IPSec-connection to a AVM FRITZ!Box 7490 on its own
1004 0
Archer MR400 IPSec VPN
5155 0
MR6400 VPN IPSec
1479 0
Archer MR400 IPSec VPN
245 0
IPsec VPN on a TL-MR6400.
211 0
MR600 V3 IPSec VPN Spec,but no instructions or setting entry??
650 0
About Us
Press
Copyright © TP-Link Systems Inc. All rights reserved.