unable to set static IP
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Hi. I just buyed an X60 from Amazon Spain.
I'm having a hard time setting up a static ip for the X60. I had an installation that worked perfectly for me with my old router. The idea was to replace my old router with the X60. I have a 4g router that provides internet service to the house. That 4g router has the ip 192.168.2.1. Apart from that, I needed to install the X60 with the IP 192.168.2.3 and also be the one to manage the static IPs of the other devices.
I have run into several problems:
1° there is no user manual for the configuration through the app.
2° The technical service of TP-Link Spain does not pick up the phone.
3° It does not matter what configuration I try to enter, I cannot establish the configuration as in the attached diagram.
This is the configuration I want to make:
Configurations I have tried:
1° configuration:
IPv4 > WAN >internet connection type : dynamic ip
IP LAN > IP > lan : 192.168.2.3
> subnet mask: 255.255.252.0
Problem: the app dont let me set subnet mask to 255.255.255.0 i got the following error message: "IP Lan adress and DNS server adress cant be in the same subnet". And i dont have internet service.
2° configuration:
IPv4 > WAN > Internet connection type > Connection type : Static ip
>IP Address: 192.168.2.3
> Subnet mask: 255.255.255.0
> Gateaway: 192.168.2.1
> Primary DNS: 8.8.8.8
> secondary DNS: 1.1.1.1
IP LAN > IP Lan: 192.168.68.1
> net mask: 255.255.255
Problem: I have internet service but some devices are not reachable by others because they are on another network (192.168.68.XXX). And what I want is for everyone to be on 192.168.2.XXX
How can I configure my Deco so that it complies with the diagram and that all my devices are on the same network? And where can I find a user manual for the deco mobile app?
