Home Network Community > All Threads > Printer connection not operating
< All Threads

Printer connection not operating

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Printer connection not operating

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Printer connection not operating
Printer connection not operating
2021-12-29 12:28:06
Model: TL-SG105E  
Hardware Version: V5
Firmware Version:

Having problems getting printer to work with switch Port 3 which is enabled. Flow control config is 'on' but Actual shows 'off'. - Not sure if this is the problem.

Internet is running ok through switch.

I have the MTU VLAN enabled with uplink port as 1 - which goes to laptop - is this correct?. Connection to virgin router is via port 2.

Also there is no 'save' tab to save the set up configuration once I get it set up properly.

Any help welcome.

Thanks

 

  0      
 
  0      
 
#1
Options
2 Reply
Re:Printer connection not operating
2021-12-29 16:06:55

@Mike121 

 

Hey

 

Im guessing you have a virgin router, this switch and some PCs / Laptops connected too the switch

 

In that case you do not need any MTU or VLAN on the ports, VLANs are designed to route traffic between different segmented networks and with your hardware its not required (the virgin box wont support vlan)

 

The best option is to reset the ports back to the default vlan (0 or 1 if I remember) which will operate the device as a regular switch.   Uplink Ports (trunks as they are known) are for connecting 2x or more switches and not for end devices such as PCs/Printers.  

 

The printer is likely due the VLAN you have in place, I would recommend you remove all VLANs or reset the switch and try again.  With your setup you should not require any configuration on the switch

  0  
  0  
#2
Options
Re:Printer connection not operating
2021-12-30 03:45:41

@Mike121 

 

Just to visualize your questions:

 As suggested disable MTU VLAN to set the switch as a regular one:

To save any change you've made instantly click on Apply button.

 

If you still have issues a factory default settings can be initiated here:

 

 

 

If this was helpful click on the arrow pointing upward to make it blue. If this solves your issue, click the star to make it blue and mark the post as a "Recommended Solution".
  1  
  1  
#3
Options

Information

Helpful: 0

Views: 740

Replies: 2

Related Articles
Printer connection
524 0
Network printer connection issues
810 0
Printer connection
253 0
Operating temperature
1794 0
When operating with a SIM card, the connection is regularly lost.
356 1
Connecting a Printer
496 0
About Us
Press
Copyright © TP-Link Systems Inc. All rights reserved.