Mesh with 3x Archer C7?
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Hi.
Two questions:
1) Is possible to create a mesh network with only 3x Archer C7 v5? (no repeater)
2) Is yes to first question, is possible to have these C7 (all 3x) in AP mode? I Already have an router (pfSense) in my network.
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
1) No - Can't make OneMesh between routers.
2) No - OneMesh is not supported in AP mode.
Read about OneMesh here and here.
If you have pfSense already, then you need only APs in your network.
The other solution is to by a DECO system (2x or 3x pack) and use it in AP mode - you would have better wireles experiance than OneMesh.
If you insist to have OneMesh then take one C7 and a couple of RE or PA and configure them to work in OneMesh (compatible devices).
- Copy Link
- Report Inappropriate Content
1) No - Can't make OneMesh between routers.
2) No - OneMesh is not supported in AP mode.
Read about OneMesh here and here.
If you have pfSense already, then you need only APs in your network.
The other solution is to by a DECO system (2x or 3x pack) and use it in AP mode - you would have better wireles experiance than OneMesh.
If you insist to have OneMesh then take one C7 and a couple of RE or PA and configure them to work in OneMesh (compatible devices).
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 1018
Replies: 1
Voters 0
No one has voted for it yet.