Hi all,

I had purchased the 2pack of Deco M4 v1, and the two of them work flawlessly for the past 3 weeks. I now purchased another Deco M4 v1, but this one is a bit stubborn. At first, it connected straight ahead with the other Decos and worked flawlessly for 2 days, and then the LED suddenly started flashing red and lost connectivity with the other Decos. I tried turning it off and on again, and sometimes it connects, sometimes it does not. I switched it places with the other (not main) Deco I have, and it started working for a couple of hours and then disconnected again.

I tried to remove and add it again, I pressed the RESET button on the base of the device, and it still behaves the same way, works for a few hours and the disconnects again.

I also tried to move it right next to the main Deco, and it again behaves the same way.

Is there something with the firmware itself, or is the device acting weird because of a hardware problem? How can I troubleshoot this, I cannot find any error logs on the application, and I would appreciate it if you can guide me to a solution.

My network topology consists of 3 Deco M4 v1 devices, placed in 3 different rooms with a distance of 5-10 meters each of the sattelites (with 1 or 2 walls in between) from the main Deco. There are 10 devices connected in total, 2 with ethernet and the rest with wifi.

Thank you in advance,

Thanasis

EDIT:

I found error longs through the web interface, so I am attaching them.

I also want to add that I have done multiple restarts on all Decos, and the problem with the specific one persists. While I was writing this message, the one Deco was not working, but started working when I posted this message without me doing anything to make it work (like restarting or reseting).