TP-Link Archer C20 V4
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
I bought a TP-Link Archer C20. But I cannot find the RANGE Extender mode. So please help me to configure it in RANGE EXTENDER mode.
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
You can enable the WDS bridging function to connect the extender to the main router to extend the wifi range.
You can refer to page 68 of the user guide to configure it.
https://www.tp-link.com/support/download/archer-c20/v4/#FAQs
Or you can click here to get the FAQ to set it up.
Best regards.
- Copy Link
- Report Inappropriate Content
@mkbasil Hi - I know it's very late, but there is a way you can.
1. disable DHCP on the slave router.
2. set the IP address of the slave router to one number higher than the master router.
3. set the DHCP of the master router to exclude the IP address of the slave router.
4. connect the cable to the slave router's LAN port. DO NOT USE THE WAN PORT.
- Copy Link
- Report Inappropriate Content
Information
Helpful: 1
Views: 6805
Replies: 2
Voters 0
No one has voted for it yet.