No internet when power link is turn on.

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

No internet when power link is turn on.

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
No internet when power link is turn on.
No internet when power link is turn on.
2015-10-12 12:36:20
Model :

Hardware Version : Not Clear

Firmware Version :

ISP :

I have the following Kit AV500 Powerline Wi-Fi Kit TL-WPA4226KIT and it was working fine until last week. Restarting the computer, router and modem also will not help. I tried to isolated the problems and found that the issue is with the wireless adapter (TL-WPA4220).
Tried the following steps to isolate the issues

[*]With kit turn off both wired and wireless (to router) – Connection to Internet no issues.
[*]With only TL-PA4020P turn on only – Connection to Internet no issues.
[*]With only TL-WPA4220 turn on – Connection won’t connect.

Tried resetting the set, also won’t solve the problem.
Any idea what the problems??



  0      
  0      
#1
Options
4 Reply
Re:No internet when power link is turn on.
2015-10-12 15:59:47
How about status of powerline lights on both units?
Follow the guide here to pair them first. Connect to LAN port of WPA4220 and check if interent works. If not, what's the IP address, default gateway, and DNS obtained? With direct connection to the router, what's those info obtained?
http://www.tp-link.com/en/faq-258.html
  0  
  0  
#2
Options
Can't do anything,
2015-10-15 09:23:22
Try to pair again, but it does not seem to pair as the light will not blink like what the link say. Everything remain the same.:(
  0  
  0  
#3
Options
Re:No internet when power link is turn on.
2015-10-15 14:23:28
If so, reset them first, and then pair or change network name via utility.
http://www.tp-link.com/en/faq-601.html
  0  
  0  
#4
Options
Re:No internet when power link is turn on.
2015-10-18 23:12:42
Tried the reset as shown in your link a few times. Still the same. Any other method left to do?
  0  
  0  
#5
Options