Using TL-WA 5210G as WIFI Range Extender
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Using TL-WA 5210G as WIFI Range Extender
Region : Canada
Model : TL-WA901ND
Hardware Version : V1
Firmware Version : unknown
ISP : Rogers
:confused:
I am trying to extend my wireless range to include another house about 300-500 ft away, but am having problems setting it up.
My setup is:
Netcomm 3G27WV-R 3G modem (wifi switched off, single LAN port)), ====> hardwired to Linksys 160N Router (for extra ports for local computer and TL-WA)
and local WIFI (local SSID) ====> hardwired to TL-WA5210G, which sends WIFI signal to the wireless users in the other building.
I am trying to use it as an additional wifi router, but am having problems with the DNS, I can connect to it, but not to
the internet because of DNS.
So what would be the correct setup in this case?
Model : TL-WA901ND
Hardware Version : V1
Firmware Version : unknown
ISP : Rogers
:confused:
I am trying to extend my wireless range to include another house about 300-500 ft away, but am having problems setting it up.
My setup is:
Netcomm 3G27WV-R 3G modem (wifi switched off, single LAN port)), ====> hardwired to Linksys 160N Router (for extra ports for local computer and TL-WA)
and local WIFI (local SSID) ====> hardwired to TL-WA5210G, which sends WIFI signal to the wireless users in the other building.
I am trying to use it as an additional wifi router, but am having problems with the DNS, I can connect to it, but not to
the internet because of DNS.
So what would be the correct setup in this case?
