Cannot login after IP number change
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Cannot login after IP number change
Region : Germany
Model : Archer C7
Hardware Version : Not Clear
Firmware Version : Archer C7_v1_140903
ISP : KDG
Hi,
I encountered following problem after upgrading the firmware to Archer C7_v1_140903.
Whenever I change the IP number of the router from 192.168.0.1 to 192.168.1.1 I cannot login into the WebGUI.
I setup everything after the firmware upgrade. I restarted the router several times and everything works fine.
After everything was in place i changed the IP number from 192.168.0.1 to 192.168.1.1 to meet the needs of my network.
After the restart I cannot login anymore to the WebGUI.
I reset to factory settings by pressing the reset button for 15 seconds. Everything was OK again. I changed the setup again and as before everything worked until i changed the IP address.
Same as before the router worked, but I cannot access the WebGUI.
When I enter username and password and press enter I get a new empty login mask.
Is there a work around ?? I want to use the new update for better 5GHz support.
Bye Matze
Model : Archer C7
Hardware Version : Not Clear
Firmware Version : Archer C7_v1_140903
ISP : KDG
Hi,
I encountered following problem after upgrading the firmware to Archer C7_v1_140903.
Whenever I change the IP number of the router from 192.168.0.1 to 192.168.1.1 I cannot login into the WebGUI.
I setup everything after the firmware upgrade. I restarted the router several times and everything works fine.
After everything was in place i changed the IP number from 192.168.0.1 to 192.168.1.1 to meet the needs of my network.
After the restart I cannot login anymore to the WebGUI.
I reset to factory settings by pressing the reset button for 15 seconds. Everything was OK again. I changed the setup again and as before everything worked until i changed the IP address.
Same as before the router worked, but I cannot access the WebGUI.
When I enter username and password and press enter I get a new empty login mask.
Is there a work around ?? I want to use the new update for better 5GHz support.
Bye Matze
