Can't set high priority devices

Coil42

Yesterday

Posts: 1

Helpful: 0

Solutions: 0

Stories: 0

Registered: 2025-03-05

Can't set high priority devices

Yesterday

Tags: #Bandwidth Control/QoS

Model: Deco X20

Hardware Version:

Firmware Version: 1.2.5 Build 20240720 Rel. 66739

Hi,

When I try to set a device as high priority on the deco app it automatically takes the device off. I have set QoS up and set it to gaming

I wasn't having this issue originally but tried to reset my network to get rid of another problem (lag at 8pm every night with normal ping and speedtests)

I have set my bandwidth correctly according to the plan I'm on.

Any help would be appreciated

Cheers

1 Reply

Marvin_S

12 hours ago

Posts: 2898

Helpful: 208

Solutions: 647

Stories: 0

Registered: 2022-05-09

Re:Can't set high priority devices

12 hours ago

@Coil42

Hi, welcome to our community.

It is suggested to follow the troubleshooting steps below:

1. Does the problem only happen on certain devices or whatever client device?

2. Check whether random MAC address is enabled on the device. Please disable it then observe again.

3. Please delete the QoS settings and reconfigure it following the guide. If it is the same result, please share the screenshots of your detailed settings on Deco app and the result( it automatically takes the device off) you find.

4. Is hardware version of your Deco V2?

Thank you and best regards.

Check Out the Latest Posts: Archer GE550 - BE9300 Tri-Band Wi-Fi 7 Gaming Router EasyMesh Is Available When Wi-Fi Routers Work in AP Mode as A Controller. Archer BE550 New Software Enhances System Stability and Optimizes MLO Network Stability. TL-WA3001 Supports EasyMesh, Speed Limit, Guest Network in AP Mode and/or Multi-SSID Mode.

Can't set high priority devices

Can't set high priority devices

Information

Voters 0

Tags