Archer MR600v2 (EU) Firmware Upgrade Problem
I have an Archer MR600v2 router where the firmware upgrade fails.
Current firmware:
Firmware version: 1.4.0 0.9.1 v0001.0 Build 210805 Rel.63527n
Hardware version: Archer MR600 v2 00000002
The firmware offered on the download portal (Archer_MR600(EU)v2_1.8.0_0.9.1_[240716-rel60322]_up_boot_release_2024-07-18_20.20.05) cannot be flashed and you get the error message with the error code 4503.
I think it is a german model. It was distributed in Austria.
According to some entries in the community, it is recommended to contact support about this.
I am therefore asking for support.
Kind regards
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
Hi, thanks for posting question here.
If your router is Archer MR600(EU) V2.0, you may try the firmware from the official website.
And this guide is for your reference: How to upgrade the firmware of TP-Link Wireless Dual Band 4G LTE Router
If it is the same error message, here are some suggestions for your reference:
1. Take factory reset on the router.
2. Use a wired connection instead of wireless for better stable connection.
3. Try another web browser to log into the web UI of the router.
If the steps above help little, it is suggested contact local technical support team for further help.
Thank you and best regards.
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
Use the following method
1- Install this firmware :
https://static.tp-link.com/upload/beta/2022/202208/20220812/Archer_MR600_V2_220810_DREI_to_EU.zip
2-Install this EU firmware :
https://static.tp-link.com/upload/firmware/2022/202212/20221205/Archer_MR600(EU)_V2_220105.zip
When done, Logon to MR600 and check for updates .
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 121
Replies: 4
Voters 0
No one has voted for it yet.