Firmware BUG Archer NX600
Hello,
When [Access Control] is enabled, in [network map] and in [seccurity -> acces control] information about online wired devices is not displayed. When [Acces Control] is disabled, information about online wired devices is displayed. Its only about displaying information, because even if its not displayed, everything with internet connection is ok. Please fix it, because its annoying.
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
Hi, Thank you very much for the feedback.
Does it matter whether the Access Control is set to "Whitelist or Blacklist"?
Are you able to constantly reproduce this issue?
-If yes, could you please refer to back up the current network configuration(under Advanced>System tools>Backup & Restore) and send it to support.forum@tp-link.com ?
Wait for your reply and best regards.
- Copy Link
- Report Inappropriate Content
Hi,
if Access Control is set to blacklist, wired online devices are displayed properly. So the problem occurs only when access control is set to whitelist. I can reproduce this issue constantly and as you asked, I will send you my network configuration.
There is one more issue I have noticed. I set LAN/WAN port to work as LAN port and if any device connected to this port is online, the LAN LED should be in "on" status, but its still in "off" status (internet works ok). I can not check how the LAN LED works with WAN port because I have no wired internet connection. I use only 5G.
- Copy Link
- Report Inappropriate Content
Thank you very much. The backup file has been received.
The case will be escalated to the senior engineers for further assistance. Please check the email later for more suggestions.
Best regards.
- Copy Link
- Report Inappropriate Content
Information
Helpful: 1
Views: 68
Replies: 3
Voters 1
