Disable dynamic dns without factory reset?

Disable dynamic dns without factory reset?

Disable dynamic dns without factory reset?
Disable dynamic dns without factory reset?
22 hours ago
Model: Archer MR400  
Hardware Version: V1
Firmware Version: 1.6.0 0.9.1

How to disable dynamic dns without factory reset?

Admin interface Advanced/Dynamic DNS does not allow deletion and saving.

 

  0      
  0      
#1
Options
4 Reply
Re:Disable dynamic dns without factory reset?
13 hours ago

  @jariahlstedt 

 

 

"If you want to use a new DDNS account, please log out first, and then log in with the new account."

You can always delete your registered domain name in your service provider account (Dyndns or No-IP).

If this was helpful click once on the arrow pointing upward. If this solves your issue, click once the star to mark it as a "Recommended Solution".
  0  
  0  
#2
Options
Re:Disable dynamic dns without factory reset?
12 hours ago
I don't want to delete no-ip's account or any info there. I am replacing my MR400 with a MR600 router, so the no-ip credentials in the old router MR400 are now obsolete. If I don't delete the credentials in MR400, there will be two different routers that update no-ip's dns with same credentials. I solved it by setting old router's credentials to no-ip as nonsense, even it complains when saving them in router's admin page.
  0  
  0  
#3
Options
Re:Disable dynamic dns without factory reset?
12 hours ago - last edited 12 hours ago

  @jariahlstedt 

 

A simple Log out for the No-IP account in the MR400 \WebGUI should do the job.

If this was helpful click once on the arrow pointing upward. If this solves your issue, click once the star to mark it as a "Recommended Solution".
  0  
  0  
#4
Options
Re:Disable dynamic dns without factory reset?
12 hours ago
Nope, I did a logout, but after next boot the router is back logged-in to no-ip.
  0  
  0  
#5
Options