Problems with X50 wired units after upgrade
My Deco X50 mesh system firmware was recently upgraded. Since then I have a very strange problem. I have the main X50 connected to another router, which in turn is connected to yet another router that is connected to the ISP. I have some units connected to the ISP-router, like my NAS.
On one of the satellite X50´s I have two wired units. One desktop PC and one PLC. After the upgrade I cannot access any of the wired devices from other WiFi-connected devices. I also cannot connect to the NAS anymore from any of the wired units, but no problem to connect from the WiFi units.
I can access the internet from the wired devices.
I have tested to run the Deco as both Access point (which I had before) and as Router, but no difference.
What can I do?
Hi, welcome to the community.
Is the current network topology like:
It is still suggested to set Deco into "Access Point" mode.
After the upgrade I cannot access any of the wired devices from other WiFi-connected devices.
I also cannot connect to the NAS anymore from any of the wired units, but no problem to connect from the WiFi units.
-Can you consistently reproduce this issue?
-Can you still ping(How to Use the Ping Command) these wired desktop and powerline adapters over WiFi connection?
- How about the wireless clients from the "satellite Deco X50"? can they access the wired desktop and powerline adapters?
Wait for your reply and best regards.
David-TP wrote
Hi, welcome to the community.
Is the current network topology like:
It is still suggested to set Deco into "Access Point" mode.
After the upgrade I cannot access any of the wired devices from other WiFi-connected devices.
I also cannot connect to the NAS anymore from any of the wired units, but no problem to connect from the WiFi units.
-Can you consistently reproduce this issue?
-Can you still ping(How to Use the Ping Command) these wired desktop and powerline adapters over WiFi connection?
- How about the wireless clients from the "satellite Deco X50"? can they access the wired desktop and powerline adapters?
Wait for your reply and best regards.
Hello,
Yes, the topology is more or less like your sketch.
The problem is there all the time.
I cannot ping the wired units from wifi clients, but I can ping and access the NAS and I cannot ping any of the other units from the wired clients.
I have no powerline adapters, only physical network cables and wifi.
To me it seems as if the wired clients are not allowed to access anything else but the internet.
B.r.