MR600 Antennae/Signal Strength

MR600 Antennae/Signal Strength

MR600 Antennae/Signal Strength
MR600 Antennae/Signal Strength
2024-11-24 12:41:55 - last edited 2 weeks ago
Model: Archer MR600  
Hardware Version:
Firmware Version:

Okay maybe a naive question but if I 'twiddle' my 2 antennae about the signal strength immediately goes up from 2 bars to 3 (if it was on 2 to start!!)

is there any logical reason why?

  0      
  0      
#1
Options
1 Accepted Solution
Re:MR600 Antennae/Signal Strength-Solution
2024-11-26 06:30:06 - last edited 2 weeks ago

  @WaulkmillFH 

 

Hi, welcome to our community.

I am not sure how you touch and adjust the two antennas on the router.

According to my understanding, supposing you adjusted a little bit angle of the antennas, which may influence the router received 4G signals from ISP, so the signal strength got better, because the two antennas are detachable.

It is suggested to read this thread to know more about LTE Gateway Router External Antennas

 

Recommended Solution
  0  
  0  
#2
Options
1 Reply
Re:MR600 Antennae/Signal Strength-Solution
2024-11-26 06:30:06 - last edited 2 weeks ago

  @WaulkmillFH 

 

Hi, welcome to our community.

I am not sure how you touch and adjust the two antennas on the router.

According to my understanding, supposing you adjusted a little bit angle of the antennas, which may influence the router received 4G signals from ISP, so the signal strength got better, because the two antennas are detachable.

It is suggested to read this thread to know more about LTE Gateway Router External Antennas

 

Recommended Solution
  0  
  0  
#2
Options