Hello,

I applied the latest firmware version (1.7) of Archer VR600 device. 

After this, my computer started to be unable to open web pages, even though it appeared to be connected to the internet.

I turn off the device for 5-10 minutes and cut off the power. When I start it up again, it starts working stably for a few hours. But then the same problem occurs again.

I also use a TP-Link WiFi extender. Devices connected to the internet via the extender work without any problems. But I can't even open the modem's interface. The extender's interface opens. I'm connected to the VR600 both via cable and wifi. Even if it connects, I can't get internet. And after a while, it stops giving out an IP.

I need help about that.

Also, I wonder about is it possible to apply the previous firmware version?

Thanks/Regards

Beyhan