Easymesh Router Device Connection Type Issues
Hi all.
I'm not sure if anyone else has encountered this issue when using Ethernet backhaul with EasyMesh. The device connection types and the devices listed under my router node are incorrect. As shown in the picture, it indicates that all devices are connected to the RC3000 slave node. However, this isn't accurate because my RC3000 slave node is located in a private lift, separated by a concrete wall, making it impossible for any devices to connect to it. Despite this, the dashboard shows nearly all devices connected to the RC3000 node via Ethernet, which isn't possible since my RC3000 node only had 4 ethernet port. In conclusion, the device list and connection type displayed for the slave node are not accurate at all.
I know it’s not a major issue, but I'm curious to understand what's actually going on and can TPLink do anything to fix this?
Here is my network topology diagram for reference. All my slave nodes connect back to the switch via the LAN port, not the WAN port. Previously, when I connected through the WAN port, I encountered issue. The main node router was unable to establish an Ethernet EasyMesh connection and kept switching between wireless and Ethernet.
Thanks.