Home

Forums

Stories

Knowledge Base

Home Network Community > Deco > 1/2 of the full ethernet bandwith available via WiFi on x20 v4

< Deco

1/2 of the full ethernet bandwith available via WiFi on x20 v4

Schabik

2024-09-06 09:28:13

Posts: 2

Helpful: 0

Solutions: 0

Stories: 0

Registered: 2024-09-06

1/2 of the full ethernet bandwith available via WiFi on x20 v4

2024-09-06 09:28:13

Tags: #Network Connectivity #6 GHz #Access Point Mode

Model: Deco X20

Hardware Version: V4

Firmware Version: 1.5.5 build 20240718 Rel. 44414

Hi, I have a problem with my Deco X20 v4 (3-pack, all connected via ethernet). When I'm connected via ethernet I get almost full bandwith (1Gb/s symetrical) but when I'm either on my laptop and my desktop (both with the Intel AX210 WiFi cards), my S23 Ultra or S9 tablet or my Steam Deck then wherever I go in my 5 room 1'st floor I got fill signal (or almost full) but always download varies from 300Mb/s to 600Mb/s and upload always varies from 500Mb/s to 600Mb/s, even when I'm near the main Deco X20 device connected to the router from the ISP (in the same room to be exact)....

2 Reply

Sunshine

2024-09-10 10:14:04

Posts: 7368

Helpful: 1191

Solutions: 866

Stories: 0

Registered: 2018-12-17

Re:1/2 of the full ethernet bandwith available via WiFi on x20 v4

2024-09-10 10:14:04

@Schabik

Hi,

Please use a device to test the download you can get from the main Deco. You can set up the WIFI settings as 5G only and then test the speed again.

If you still find the speed is slow, you can also try the suggestions here.

Troubleshooting Slow Internet Speed with Deco Devices

Nice to Meet You in Our TP-Link Community. Check Out the Latest Posts: Archer GE550 - BE9300 Tri-Band Wi-Fi 7 Gaming Router EasyMesh Is Available When Wi-Fi Routers Work in AP Mode as A Controller. Archer BE550 New Software Enhances System Stability and Optimizes MLO Network Stability. TL-WA3001 Supports EasyMesh, Speed Limit, Guest Network in AP Mode and/or Multi-SSID Mode. If you found the post or response helpful, please click Helpful. If an answer solves your problem, click "Recommended Solution" so that others can benefit from it.

Schabik

LV1

2024-10-03 13:20:45

Posts: 2

Helpful: 0

Solutions: 0

Stories: 0

Registered: 2024-09-06

Re:1/2 of the full ethernet bandwith available via WiFi on x20 v4

2024-10-03 13:20:45

sorry for the delay, tested the settings You told me about and transfers are the same, maybe slightly better on my MSI Cyborg 15 with Intel AX211 it's now 650⬇️ and ~703⬆️ . On my S23 Ultra there is an decrease in both ⬇️ and ⬆️ when I set it to the main Deco.

1/2 of the full ethernet bandwith available via WiFi on x20 v4

1/2 of the full ethernet bandwith available via WiFi on x20 v4

Information

Voters 0

Tags