local https access - 403 forbidden

local https access - 403 forbidden

local https access - 403 forbidden
local https access - 403 forbidden
2024-09-03 10:57:26 - last edited 2024-09-14 08:21:03
Model: Archer MR600  
Hardware Version:
Firmware Version:

 

I tried to setup remote management on MR600. Instead of that I accidently ticked and enable local https access and also input a WAN IP address. As a result I can not login to the device locally any more. Is there any way to log in without default the device? Thanks

  0      
  0      
#1
Options
1 Accepted Solution
Re:local https access - 403 forbidden-Solution
2024-09-04 00:49:35 - last edited 2024-09-14 08:21:03

  @mak50 

 

If you've checked the Only Allow the Following IP and entered your WAN IP adddress:

 

You should reset the modem and reconfigure from scratch,

If you've made any configuration backup prior to that, restore the the configuration from that backup.

If this was helpful click once on the arrow pointing upward. If this solves your issue, click once the star to mark it as a "Recommended Solution".
Recommended Solution
  2  
  2  
#2
Options
1 Reply
Re:local https access - 403 forbidden-Solution
2024-09-04 00:49:35 - last edited 2024-09-14 08:21:03

  @mak50 

 

If you've checked the Only Allow the Following IP and entered your WAN IP adddress:

 

You should reset the modem and reconfigure from scratch,

If you've made any configuration backup prior to that, restore the the configuration from that backup.

If this was helpful click once on the arrow pointing upward. If this solves your issue, click once the star to mark it as a "Recommended Solution".
Recommended Solution
  2  
  2  
#2
Options