Archer MR400 NAT-T nat traversal required

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Archer MR400 NAT-T nat traversal required

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Archer MR400 NAT-T nat traversal required
Archer MR400 NAT-T nat traversal required
2024-06-06 06:56:31
Model: Archer MR400  
Hardware Version: V3
Firmware Version: 1.12.00.9.1

hallo, I need to have in MR400 V3 protocol NAT-T (nat traversal) on port 4500. Is there available any beta firmware with it? thank you

 

  0      
  0      
#1
Options
2 Reply
Re:Archer MR400 NAT-T nat traversal required
2024-06-07 07:41:16

  @ik4not 

Hi,

 

May I know your network topology? NAT forwarding should also be able to satisfy you demands.

Nice to Meet You in Our TP-Link Community. Check Out the Latest Posts: Archer GE550 - BE9300 Tri-Band Wi-Fi 7 Gaming Router EasyMesh Is Available When Wi-Fi Routers Work in AP Mode as A Controller. Archer BE550 New Software Enhances System Stability and Optimizes MLO Network Stability. TL-WA3001 Supports EasyMesh, Speed Limit, Guest Network in AP Mode and/or Multi-SSID Mode. If you found the post or response helpful, please click Helpful. If an answer solves your problem, click "Recommended Solution" so that others can benefit from it.
  0  
  0  
#2
Options
Re:Archer MR400 NAT-T nat traversal required
2024-06-07 18:40:21

  @ik4not  IPsec site to site. Responder site has static IP, but caller site Is behind ISP Nat and has a private dinamic natted ip

  0  
  0  
#3
Options