Home

Forums

Stories

Knowledge Base

Home Network Community > Wi-Fi Routers > BE800 --> BE550 Ethernet Backhaul

< Wi-Fi Routers

BE800 --> BE550 Ethernet Backhaul

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

BE800 --> BE550 Ethernet Backhaul

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

MikeB75

2024-05-08 14:48:49 - last edited 2024-05-09 02:45:25

Posts: 2

Helpful: 0

Solutions: 0

Stories: 0

Registered: 2024-05-08

BE800 --> BE550 Ethernet Backhaul

2024-05-08 14:48:49 - last edited 2024-05-09 02:45:25

Tags: #EasyMesh #EasyMesh Ethernet Backhaul

Model: Archer BE800

Hardware Version: V1

Firmware Version: 1.1.1 Build 20240227 rel.33191

Hi - I'm trying to linked my BE800 to my BE550 via ethernet to extend my wireless network. I have the BE550 set up in AP mode, but would much prefer to have it be a mesh node. There is conflicting information on whether or not these two routers support an ethernet backhaul. Can I get a definitive answer and ideally instructions on how to make this happen?

Many thanks,

Mike

1 Accepted Solution

terziyski

LV7

2024-05-08 16:18:02 - last edited 2024-05-09 02:37:05

Posts: 7107

Helpful: 5326

Solutions: 1204

Stories: 7

Registered: 2013-10-12

Re:BE800 --> BE550 Ethernet Backhaul-Solution

2024-05-08 16:18:02 - last edited 2024-05-09 02:37:05

@MikeB75

Both BE800 and BE550 support Easymesh ethernet backhaul - details.

Your BE550 should be in wireless router mode (factory reset) to configure this - here's a guide.

If this was helpful click on the arrow pointing upward to make it blue. If this solves your issue, click the star to make it blue and mark the post as a "Recommended Solution".

Recommended Solution

2 Reply

terziyski

LV7

2024-05-08 16:18:02 - last edited 2024-05-09 02:37:05

Posts: 7107

Helpful: 5326

Solutions: 1204

Stories: 7

Registered: 2013-10-12

Re:BE800 --> BE550 Ethernet Backhaul-Solution

2024-05-08 16:18:02 - last edited 2024-05-09 02:37:05

@MikeB75

Both BE800 and BE550 support Easymesh ethernet backhaul - details.

Your BE550 should be in wireless router mode (factory reset) to configure this - here's a guide.

If this was helpful click on the arrow pointing upward to make it blue. If this solves your issue, click the star to make it blue and mark the post as a "Recommended Solution".

BE800 --> BE550 Ethernet Backhaul

BE800 --> BE550 Ethernet Backhaul

Information

Voters 0

Tags