Deco keeps showing ACESS MODE and "no internet"

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Deco keeps showing ACESS MODE and "no internet"

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

KraftwerkTurbo

2024-03-29 12:50:54

Posts: 6

Helpful: 0

Solutions: 0

Stories: 0

Registered: 2024-03-29

Deco keeps showing ACESS MODE and "no internet"

2024-03-29 12:50:54

Tags: #Access Point Mode

Model: Deco W2400

Hardware Version:

Firmware Version:

I had switched to acces mode (was suggested to make file sharing on network computers possible). Gave up after a while, and switched back to Router Mode.

Modem hardwired to 1st Deco. From there to hub (for other hardwired computers). 2nd Deco hardwired. 3rd Deco wifi.

Deco app says "Router Mode". But Wi Fi on computer show status "Access Point".

Connects to network, but "no internet"

1 Reply

terziyski

LV7

2024-03-29 13:59:17

Posts: 6928

Helpful: 5168

Solutions: 1111

Stories: 7

Registered: 2013-10-12

Re:Deco keeps showing ACESS MODE and "no internet"

2024-03-29 13:59:17

@KraftwerkTurbo

If you have a modem router which does NAT it's suggested to use the Deco in AP mode to avoid double NAT in your local network.

If you have a pure modem the Deco should work in router mode. Some consideration using an ethernet backhaul with Deco - here.

In any case of mis-configuration you could reset Deco's to its factory defaults an re-configure from scratch.

If this was helpful click once on the arrow pointing upward. If this solves your issue, click once the star to mark it as a "Recommended Solution".

Deco keeps showing ACESS MODE and "no internet"

Deco keeps showing ACESS MODE and "no internet"

Information

Voters 0

Tags