TPLINK Archer MR200 3G/4G Mdem not working for Grameenphone SIM card [Bangladesh]
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
It works with some operators like "ROBI". But it doesn't work with "GRAMEENPHONE" operator. I have tried many times. Please release update with fixes.
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
Hi, there could be several reasons why you are not able to access the internet or receive a signal with your 4G LTE router. Here are a few troubleshooting steps you can try:
1. Check your SIM card and network coverage: Ensure that your SIM card works fine on other 4G devices and you are within the coverage area of your mobile service provider. Weak signal reception can result in poor internet connection or no connection at all.
2. Make sure your SIM card has been detected by the 4G LTE Router and not locked by PIN code. You could check SIM Card Status on Advanced->Status page to confirm it:
If it shows "No SIM card detected", follow this guide for troubleshooting: https://www.tp-link.com/support/faq/3486/
If it shows "PIN Required", go to Advanced->Network->PIN Management to enter PIN code of your SIM card to unlock it.
3. Verify APN profile settings: Check if the Access Point Name (APN) settings on Advanced->Network->Internet page are correct. If not, try other available profile or create a new profile manually.
4. Factory reset the 4G LTE Router, pressing and holding the reset button for about 10 seconds. Keep in mind that this will erase any customized settings, so make sure to note them down before resetting.
5. If the above suggestions did not resolve the issue, this is a detailed FAQ for more troubleshooting tips: https://www.tp-link.com/support/faq/2842/
- Copy Link
- Report Inappropriate Content
@Sunshine I have followed all the steps.
There is 75% signal but still no internet.
If I select IPv4 and IPv6 it showsas connected however no internet.
Mobile phones works and some other sim cards work but that specific operator (GRAMEENPHONE) won't work. I think it is something related to router/network configurations.
I request TP link team to investigate and release new firmware upgrade with fixes so that it becomes plug and play.
- Copy Link
- Report Inappropriate Content
Hi, you mentioned that If you select IPv4 and IPv6 it shows as connected however no internet, may I have a screenshot of Advanced->Status page and Advanced->Network->Internet page?
Please also try to select PDP Type as IPv4 only and share with us the screenshots again.
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 649
Replies: 5
Voters 0
No one has voted for it yet.