Falla de identificacion via cable a la pc no emana ninguna señal wifi, no puedo entrar a la terminal
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Compre un nuevo Tp- Link Ac 1200 de 300 Mbs para reemplazar el que ya tenia, pero al conectarlo no emanana ninguna señal inicial como wifi, luego al conectarlo a la pc, tampoco lo detecta y se mantiene en verificando conexion. Me sugirieron cambiar la direccion IP a estatica para poder acceder al router, pero nada a funcionado.
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
Normally Power LED should be solid on after it boots up, and WiFi LED should be on as well, if it is still the same after factory reset, please check waranty and get it replaced, it seems to be a hardware issue.
- Copy Link
- Report Inappropriate Content
Hi, what about the LED status on the VR300? is the WiFi LED light up?
Please try reset the device to factory defaults by holding reset button/hole for about 10s until power LED flashing. Then check if any client device can see the default TP-Link WiFi.
If still no any WiFi signal, I am afraid the device is defective, you could contact the retailer to get it replaced.
- Copy Link
- Report Inappropriate Content
@Luz solar Al encender el equipo la lu de encendido se mantiene parpadeando, el resto de las luces ninguna. Solo al conectar a la pc via Lan se enciende la luz de conexion. Sin embargo solo indica en la conexion "Red no identificada" por eso tampoco puedo entrar directamente al sistema interno para actualiar el fimware. ¿Existe algun otro metodo para flashear el fimware que no sea desde la configuracion interna?
- Copy Link
- Report Inappropriate Content
Normally Power LED should be solid on after it boots up, and WiFi LED should be on as well, if it is still the same after factory reset, please check waranty and get it replaced, it seems to be a hardware issue.
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 387
Replies: 3
Voters 0
No one has voted for it yet.