Second eth port on Router mode

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Second eth port on Router mode

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Second eth port on Router mode
Second eth port on Router mode
2024-01-29 09:27:56 - last edited 2024-01-29 10:56:38
Model: Deco X10  
Hardware Version:
Firmware Version: 1.0.5

Hello everyone,
I would like to configure my deco x10 in ruoter wifi-mode and use its internal DHCP, but I need a wired ethernet port for HomeAssistant.
Can I then set the WAN port and LAN?
Thanks Donato

  0      
  0      
#1
Options
2 Reply
Re:Second eth port on Router mode
2024-01-30 06:16:26

  @dmattiazzi 

Hi, welcome to the community.

It doesn't support to set the WAN port and LAN but will be supported later on the Deco APP.

Currently, it is still WAN/LAN auto-sensing. HomeAssistant would still work well when it is connected to another Ethernet port from the main Deco.

As long as the ISP modem is active and could assign IP address to the main Deco, you will have a fixed WAN port.

Thank you very much and best regards.

  0  
  0  
#2
Options
Re:Second eth port on Router mode
2024-01-30 08:49:47

  @dmattiazzi 

Hi, if I change them with X20s, is this functionality already active?
Alternatively, can you tell me about a daco Wifi6 mesh system where it is already available?
Thank you

  0  
  0  
#3
Options