Just Installed TL-SG105-M2 , Now Can't Print

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

2023-11-30 20:45:41

Posts: 1

Helpful: 2

Solutions: 0

Stories: 0

Registered: 2023-11-30

Just Installed TL-SG105-M2 , Now Can't Print

2023-11-30 20:45:41

Model: TL-SG105-M2

Hardware Version: V1

Firmware Version:

My Printer ( Brother MFC-J880DW ) is Attached Via Cat 5 with the TL-SG105-M2 and it was working perfectly with the Old Switch TP-Link 10/100/1000.

Now with the new TL-SG105-M2 installed , it Says Offline and won't print.

I have the Input Cable at the right End of the TL-SG105-M2 and the Printer in One of the other sockets.

To Prove that the Problem is with the TL-SG105-M2, I Replaced the TL-SG105-M2 with the Old 10/100/1000 and it Works.

Any Help would be appreciated

1 Reply

LV7

2023-12-01 03:43:13

Posts: 6975

Helpful: 5189

Solutions: 1126

Stories: 7

Registered: 2013-10-12

Re:Just Installed TL-SG105-M2 , Now Can't Print

2023-12-01 03:43:13

Usually those are cabling issues which are resolved by changing the ethernet cable.

If you have other devices connected to the switch and they are OK, change the printer cable.

If this was helpful click once on the arrow pointing upward. If this solves your issue, click once the star to mark it as a "Recommended Solution".