Home Network Community > Wi-Fi Routers > TP-Link TL-WR741ND Flashes constantly after firmware upgrade
< Wi-Fi Routers

TP-Link TL-WR741ND Flashes constantly after firmware upgrade

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

TP-Link TL-WR741ND Flashes constantly after firmware upgrade

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
TP-Link TL-WR741ND Flashes constantly after firmware upgrade
TP-Link TL-WR741ND Flashes constantly after firmware upgrade
2023-11-25 01:42:29
Tags: #Firmware Update #Failed
Model: TL-WR741ND  
Hardware Version: V4
Firmware Version: 4

After updating my TL-WR741ND router, it kept flashing constantly and the message on the screen only said wait for the router to restart. A few hours passed and he didn't react. Unfortunately it was disconnected from the power and when I reconnected it the behavior is the same and I cannot access it in any way. Is there any way to access it through some software or button combination, to enter ssh or telnet? I performed the procedure from a Windows 10 PC connected by cable directly to the router

  0      
 
  0      
 
#1
Options
2 Reply
Re:TP-Link TL-WR741ND Flashes constantly after firmware upgrade
2023-11-27 09:30:11

  @Galegomca 

 

Hi, it seems that the device has been bricked by the firmware update, you could try following this guide to see if it can be recovered: 

How to recover the router when it bricked

Nice to Meet You in Our TP-Link Community. Check Out the Latest Posts: Archer GE550 - BE9300 Tri-Band Wi-Fi 7 Gaming Router EasyMesh Is Available When Wi-Fi Routers Work in AP Mode as A Controller. Archer BE550 New Software Enhances System Stability and Optimizes MLO Network Stability. TL-WA3001 Supports EasyMesh, Speed Limit, Guest Network in AP Mode and/or Multi-SSID Mode. If you found the post or response helpful, please click Helpful. If an answer solves your problem, click "Recommended Solution" so that others can benefit from it.
  0  
  0  
#2
Options
Re:TP-Link TL-WR741ND Flashes constantly after firmware upgrade
2023-11-27 18:49:38
Hi @sunshine I have tried to do the steps you mention but the model is not completely accurate and I don't know if this is the reason why it doesn't work for me. I have tried to download tftpd but when I connect my PC to a manual IP, I see that the network interface remains as not connected, it tries to connect and the cable disconnected message appears again. I imagine it's because the router never stops flashing and I can't connect to it. I don't know if for my model, TL-WR741ND, there is a combination of buttons to press since it only has the buttons: reset, power and QSS.
  0  
  0  
#3
Options

Information

Helpful: 0

Views: 499

Replies: 2

Tags

Firmware Update
Failed
Related Articles
OEM stock firmware for TL-WR741ND
825 0
My first lesson with tp-link wr741nd
1073 0
 No TP-Link firmware update TL-WR741ND
1328 0
 Help ME my Tp-Link Wr741ND
562 0
 thomson st510v6 192.168.1.254 >> to tp link tL- wr741nd
2382 0
How to get support from TP-link, when red lights flashes in setup!
1701 0
About Us
Press
Copyright © TP-Link Systems Inc. All rights reserved.