Archer MR600 V2 - QOS not working correctly

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Archer MR600 V2 - QOS not working correctly

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Archer MR600 V2 - QOS not working correctly
Archer MR600 V2 - QOS not working correctly
2023-11-02 14:53:21
Model: Archer MR600  
Hardware Version: V2
Firmware Version: 1.7.0 0.9.1 v0001.0 Build 220826 Rel.58057n

I am have been using the Router for several years now and have not found a solution yet. I get bad ping when someone uses bandwith (even though it is less than available) When I select QOS and enable it, setup the Bandwith per Device and priorities, it should fix this as far as i know but it just does not do anything.

  0      
  0      
#1
Options
1 Reply
Re:Archer MR600 V2 - QOS not working correctly
2023-11-03 10:54:25

  @niemals_sebi 

 

Bad ping could be caused by different factors, may I know if the issue happens with you ping the MR600 LAN IP address or when you ping other public address?

Please share with us more details about the issue and also the number and usage scenarios of your client devices?

Nice to Meet You in Our TP-Link Community. Check Out the Latest Posts: Archer GE550 - BE9300 Tri-Band Wi-Fi 7 Gaming Router EasyMesh Is Available When Wi-Fi Routers Work in AP Mode as A Controller. Archer BE550 New Software Enhances System Stability and Optimizes MLO Network Stability. TL-WA3001 Supports EasyMesh, Speed Limit, Guest Network in AP Mode and/or Multi-SSID Mode. If you found the post or response helpful, please click Helpful. If an answer solves your problem, click "Recommended Solution" so that others can benefit from it.
  2  
  2  
#2
Options