4G+ led is not active

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

4G+ led is not active

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

boldorv

2023-08-17 15:06:52 - last edited 2023-08-18 08:56:45

Posts: 1

Helpful: 0

Solutions: 0

Stories: 0

Registered: 2023-08-17

4G+ led is not active

2023-08-17 15:06:52 - last edited 2023-08-18 08:56:45

Tags: #Carrier Aggregation

Model: Archer MR600

Hardware Version: V3

Firmware Version:

Hello

How can I configure my Archer to have 4G+ active ?

Thanks

1 Accepted Solution

Sunshine

2023-08-18 08:56:24 - last edited 2023-08-18 08:56:29

Posts: 7375

Helpful: 1222

Solutions: 940

Stories: 0

Registered: 2018-12-17

Re:4G+ led is not active-Solution

2023-08-18 08:56:24 - last edited 2023-08-18 08:56:29

@boldorv

Hi, 4G+ or carrier aggregation is enabled by default on MR600, but whether it will work on 4G+ depends on the base station as well, if there is any issue, please refer to this post for troubleshooting:

Carrier Aggregation or 4G+ doesn’t work properly on LTE Advanced Router

Nice to Meet You in Our TP-Link Community. Check Out the Latest Posts: Archer GE550 - BE9300 Tri-Band Wi-Fi 7 Gaming Router EasyMesh Is Available When Wi-Fi Routers Work in AP Mode as A Controller. Archer BE550 New Software Enhances System Stability and Optimizes MLO Network Stability. TL-WA3001 Supports EasyMesh, Speed Limit, Guest Network in AP Mode and/or Multi-SSID Mode. If you found the post or response helpful, please click Helpful. If an answer solves your problem, click "Recommended Solution" so that others can benefit from it.

4G+ led is not active

4G+ led is not active

Information

Voters 0

Tags