Home

Forums

Stories

Knowledge Base

Home Network Community > Range Extenders > Cascading RE300 in OneMesh network, is it possible?

< Range Extenders

Cascading RE300 in OneMesh network, is it possible?

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Cascading RE300 in OneMesh network, is it possible?

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Cyrex

2023-07-26 08:24:44

Posts: 7

Helpful: 1

Solutions: 0

Stories: 0

Registered: 2020-01-07

Cascading RE300 in OneMesh network, is it possible?

2023-07-26 08:24:44

Tags: #OneMesh

Model: RE300

Hardware Version: V1

Firmware Version: 1.0.8

Good Morning,

I have one Archer MR600 and one RE300 connected with OneMesh.

I would like to add more RE300 to extend network , but I cannot move MR600 so the only option is to connect new RE300 via the signal of the existing RE300 one.

Is it possible? Does RE300 cascade configuration with other RE300 works?

Thanks in advance!

2 Reply

Sunshine

2023-07-28 09:54:14

Posts: 7375

Helpful: 1248

Solutions: 941

Stories: 0

Registered: 2018-12-17

Re:Cascading RE300 in OneMesh network, is it possible?

2023-07-28 09:54:14

@Cyrex

Hi, yes, the second extender could connect wirelessly to the first extender, but for better signal quality, it is recommended not to connect more than two extenders in one chain.

Nice to Meet You in Our TP-Link Community. Check Out the Latest Posts: Archer GE550 - BE9300 Tri-Band Wi-Fi 7 Gaming Router EasyMesh Is Available When Wi-Fi Routers Work in AP Mode as A Controller. Archer BE550 New Software Enhances System Stability and Optimizes MLO Network Stability. TL-WA3001 Supports EasyMesh, Speed Limit, Guest Network in AP Mode and/or Multi-SSID Mode. If you found the post or response helpful, please click Helpful. If an answer solves your problem, click "Recommended Solution" so that others can benefit from it.

Cyrex

LV1

2023-08-21 08:03:08

Posts: 7

Helpful: 1

Solutions: 0

Stories: 0

Registered: 2020-01-07

Re:Cascading RE300 in OneMesh network, is it possible?

2023-08-21 08:03:08

Thanks for the feedback . I succeeded in configuring cascade , although I had to do it in this way : MR600 - RE330 - RE300 while MR600 - RE300 - RE330 was not working , sounds like better extension of RE330 , but at boundaries , was creating corner case in network reachability.

Cascading RE300 in OneMesh network, is it possible?

Cascading RE300 in OneMesh network, is it possible?

Information

Voters 0

Tags