Deco X20 Network Setup *Novice User*
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Hi everyone,
I need some advice on my network setup. I recently bought the Deco X20 setup with 3 units and got myself into a right old mess!!!
I managed to restart the set up from scratch again and have got things running, but for some reason 1 of the units isn't working and either stays flashing green or solid green.
It doesn't show up on the deco app and deosn't connect to anything. While deleting the old network and starting a fresh and got the untis mixed up, and i think the one I have an issue with was the one that was originally set up as the main one.
Basically, I am trying to find out how i can reset this unit and get it up and running again. (I have tried various things via internet but without any luck.
Apologies if this hasn't explained much as I'm completely new to this.
Many thanks for your time,
Dan
Hi, welcome to the community.
You could refer to this picture to get information on the LED status of Deco X20:
So if the LED is solid green, the Deco X20 is working great. As for flashing green, if it is not under the firmware upgrade, it is suggested to reset it once by holding the reset pinhole for 1s. Then monitor for a while whether the same issue would repeat.
Thank you very much.
Best regards.