4g+ light comes on and off since firmware update

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

4g+ light comes on and off since firmware update

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
4g+ light comes on and off since firmware update
4g+ light comes on and off since firmware update
2023-07-13 10:29:04 - last edited 2023-07-13 11:07:00
Model: Archer MR600  
Hardware Version: V2
Firmware Version: 170091v00010 build 220826 REL 58057n

It's an Archer mr600 since a firmware update the  4g+ has been intermittently going on and off and speeds drop and increase as per the light 

then this morning the power goes off then comes back on the power light flashing then WiFi light comes on then it dies and starts again it sometimes makes it and works then drops wifi in and out 

  0      
  0      
#1
Options
2 Accepted Solutions
Re:4g+ light comes on and off since firmware update-Solution
2023-07-13 11:03:42 - last edited 2023-07-13 11:07:00
Recommended Solution
  0  
  0  
#2
Options
Re:4g+ light comes on and off since firmware update-Solution
2023-07-14 07:25:42 - last edited 2023-07-14 07:25:46

  @Invader996 

 

Hello, for carrier aggregation/4G+ issue, please refer to this post: Carrier Aggregation or 4G+ doesn’t work properly on LTE Advanced Router

Nice to Meet You in Our TP-Link Community. Check Out the Latest Posts: Archer GE550 - BE9300 Tri-Band Wi-Fi 7 Gaming Router EasyMesh Is Available When Wi-Fi Routers Work in AP Mode as A Controller. Archer BE550 New Software Enhances System Stability and Optimizes MLO Network Stability. TL-WA3001 Supports EasyMesh, Speed Limit, Guest Network in AP Mode and/or Multi-SSID Mode. If you found the post or response helpful, please click Helpful. If an answer solves your problem, click "Recommended Solution" so that others can benefit from it.
Recommended Solution
  0  
  0  
#3
Options
2 Reply
Re:4g+ light comes on and off since firmware update-Solution
2023-07-13 11:03:42 - last edited 2023-07-13 11:07:00
Recommended Solution
  0  
  0  
#2
Options
Re:4g+ light comes on and off since firmware update-Solution
2023-07-14 07:25:42 - last edited 2023-07-14 07:25:46

  @Invader996 

 

Hello, for carrier aggregation/4G+ issue, please refer to this post: Carrier Aggregation or 4G+ doesn’t work properly on LTE Advanced Router

Nice to Meet You in Our TP-Link Community. Check Out the Latest Posts: Archer GE550 - BE9300 Tri-Band Wi-Fi 7 Gaming Router EasyMesh Is Available When Wi-Fi Routers Work in AP Mode as A Controller. Archer BE550 New Software Enhances System Stability and Optimizes MLO Network Stability. TL-WA3001 Supports EasyMesh, Speed Limit, Guest Network in AP Mode and/or Multi-SSID Mode. If you found the post or response helpful, please click Helpful. If an answer solves your problem, click "Recommended Solution" so that others can benefit from it.
Recommended Solution
  0  
  0  
#3
Options