AX1500 Router Doesn't Receive Connection
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.AX1500 Router Doesn't Receive Connection
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Good afternoon.
I received my Archer AX1500 yesterday to improve my shoddy TalkTalk connection in our 19th century house. However after setting it up according to the intructions, the device fails to receive connection (orange light) and there appears to be no IP address used when logging into the setup.
I'm using Default MAC address and Dynamic IP. Also using a relatively new cable from one of my powerline adapters as it's longer than the one provided.
The connections seem sturdy, I've double checked and I've restarted the router several times and plugged them in according to the instructions, to no avail.
Is this a problem with my ISP? Or is there something I'm doing wrong here?
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
Hi,
Have you connected the Archer AX1500's blue "WAN" port via cable to one of the LAN Ethernet ports of the TalkTalk router (or "hub")?
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
Then that's the reason why the AX1500 doesn't obtain an IP address for its Internet connection.
If you have the TalkTalk hub that looks like a book standing upright on its long side, then you need to plug the cable inside one of the four yellow "Ethernet" ports.
- Copy Link
- Report Inappropriate Content
This seemed to help, thanks! The light is green now. However the connection is very unstable. It'll connect and say I've got a full bar of signal and then it will just disconnect :/
- Copy Link
- Report Inappropriate Content
Are you saying the (wireless) connection became unstable after you've moved the cable from the WAN port to one of the Ethernet ports?
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
How long is that cable you took from one of your Powerline adapters actually?
In case you've left the Wi-Fi signals from the TalkTalk hub switched on, then you should place the AX1500 router a reasonable distance away from the TalkTalk hub, to prevent the Wi-Fi signals from interfering with each other. (especially if both Wi-Fi routers were to broadcast on the same frequencies)
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
Hi,
A meter is extremely close. That could certainly lead to problems. I suggest you switch the Wi-Fi of the TalkTalk hub off and then check again how the AX1500 behaves.
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 1234
Replies: 16
Voters 0
No one has voted for it yet.