Archer MR600 “died”

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Archer MR600 “died”

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Archer MR600 “died”

Eric_M64

2023-05-31 12:19:40 - last edited 2023-05-31 12:32:50

Posts: 1

Helpful: 0

Solutions: 0

Stories: 0

Registered: 2023-05-31

Archer MR600 “died”

2023-05-31 12:19:40 - last edited 2023-05-31 12:32:50

Model: General Product

Hardware Version: V2

Firmware Version:

When updating the firmware (Archer MR600), there was a power outage and then the router does not turn on and cannot be seen through the LAN port. At the same time, when the power is turned on, all the indicators light up, then they go out, the power indicator lights up for a few seconds, and then it starts flashing quickly... How can I restore the device?

1 Reply

Sunshine

2023-06-01 01:32:14

Posts: 7312

Helpful: 1178

Solutions: 784

Stories: 0

Registered: 2018-12-17

Re:Archer MR600 “died”

2023-06-01 01:32:14

@Eric_M64

Hi, MR600 doesn't support firmware recovery, it looks like the device has been bricked due to the power outage during the firmware update.

If factory reset doesn't help either, I am afraid you will need to contact the retailer to see if it is covered by the warranty or purchase a new one.

Nice to Meet You in Our TP-Link Community. Check Out the Latest Posts: Archer GE550 - BE9300 Tri-Band Wi-Fi 7 Gaming Router EasyMesh Is Available When Wi-Fi Routers Work in AP Mode as A Controller. Archer BE550 New Software Enhances System Stability and Optimizes MLO Network Stability. TL-WA3001 Supports EasyMesh, Speed Limit, Guest Network in AP Mode and/or Multi-SSID Mode. If you found the post or response helpful, please click Helpful. If an answer solves your problem, click "Recommended Solution" so that others can benefit from it.

Archer MR600 “died”

Archer MR600 “died”

Information

Voters 0

Tags