Home

Forums

Stories

Knowledge Base

Home Network Community > Deco > Force device to use default router

< Deco

Force device to use default router

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Force device to use default router

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Force device to use default router

2023-02-28 08:49:09 - last edited 2024-11-01 02:08:09

Posts: 2

Helpful: 2

Solutions: 0

Stories: 0

Registered: 2023-02-28

Force device to use default router

2023-02-28 08:49:09 - last edited 2024-11-01 02:08:09

Tags: #Port Forwarding #VPN #WireGuard

Model: Deco E4

Hardware Version:

Firmware Version:

Dear community,

Since I have installed my TP link deco E4 set my Raspberry Pi which is wired to my main router also uses the TP link network.

Is there a way to force this device to use my 'initial' network instead of the TP link network?

Because somehow my Wireguard client on the raspberry pi is not accessible anymore. Also tried opening the ports (more -> advanced -> port forwarding) 51820 and disabled this setting on my router's interface/ kept them open at the same time but none of these actions result in a working Wireguard client.

Thanks in advance

0

0

#1

1 Accepted Solution

2023-03-01 06:43:56 - last edited 2023-03-02 06:51:32

Posts: 12796

Helpful: 1796

Solutions: 1294

Stories: 9

Registered: 2020-04-14

Re:Force device to use default router-Solution

2023-03-01 06:43:56 - last edited 2023-03-02 06:51:32

Hi, welcome to the community.

Have you tried to set up Deco into Access Point mode so that all the LAN devices will get IP addresses from the ISP router:

How to set up Deco to work in Access Point mode

Best regards.

▶Check What's Currently Going on With Deco ▶Deco Starts Supporting Changing Wireless Channels! ▶KidShield Now Open for Trial! Try to leave a Message if urgent help is required.

Recommended Solution

0

0

#2

2 Reply

2023-03-01 06:43:56 - last edited 2023-03-02 06:51:32

Posts: 12796

Helpful: 1796

Solutions: 1294

Stories: 9

Registered: 2020-04-14

Re:Force device to use default router-Solution

2023-03-01 06:43:56 - last edited 2023-03-02 06:51:32

Hi, welcome to the community.

Have you tried to set up Deco into Access Point mode so that all the LAN devices will get IP addresses from the ISP router:

How to set up Deco to work in Access Point mode

Best regards.

▶Check What's Currently Going on With Deco ▶Deco Starts Supporting Changing Wireless Channels! ▶KidShield Now Open for Trial! Try to leave a Message if urgent help is required.

Recommended Solution

0

0

#2

LV1

2023-03-02 06:51:23

Posts: 2

Helpful: 2

Solutions: 0

Stories: 0

Registered: 2023-02-28

Re:Force device to use default router

2023-03-02 06:51:23

Thanks a lot! This works. Now I can enjoy fast internet everywhere in the house and still use the raspberry. :)

Kind regards,

Mike

1

1

#4