Issue with current RE450 V4 update where it adds EasyMesh function
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
The new update where the EasyMesh function was added to the RE450 V4 model has a very annoying bug, which after being updated puts the device's coverage to the lowest and even when selecting the highest coverage it restarts but does not apply the maximum coverage option , leaving it always in the minimum coverage, and nothing solves this problem, so I came here to report this problem, I already went back to the previous version because I need good coverage from this repeater and the new update leaves the signal coverage of the RE450 V4 completely limited. so i hope they fix it as soon as possible.
@Andrsouzaaa Hi, sorry for the delay, and Thanks a lot for the feedback
.
I happen to see another similar post-https://community.tp-link.com/en/home/forum/topic/597154 and Since RE550 also supports EasyMesh, I think @PrzemWas might enable EasyMesh as well.
I would like to follow up on your case via email. Please check whether you could get an email from me later.
Thank you again.
Best regards.
Wish you a Happy New year.