MR6400 V5.3

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

MR6400 V5.3

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
MR6400 V5.3
MR6400 V5.3
2022-09-13 19:19:10
Model: TL-MR6400  
Hardware Version: V5
Firmware Version: 1.3.0 0.9.1 v0001.0 Build 220113 Rel.67515n

I can't configure on on this device S2S IPSEC tunnel with these settings, on second device MR400v3 with these everything is working correctly. 

I tried also with other settings but nothing helps. 

 

Dead Peer Detection: ON

IPSec Connection Name: xxx
Remote IPSec Gateway (URL): xxx
Tunnel access from local IP addresses: Subnet Address
IP Address for VPN: 10.0.4.0
Subnet Mask: 255.255.255.0
Tunnel access from remote IP addresses: Subnet Address
IP Address for VPN: 10.0.1.0
Subnet Mask: 255.255.255.0
Key Exchange Method: Auto (IKE)
Authentication Method: Pre-Shared Key
Pre-Shared Key:xxx
Perfect Forward Secrecy: Enable


Mode: Main
Local Identifier Type: Local Wan IP
Local Identifier: ------
Remote Identifier Type:Remote Wan IP
Remote Identifier: ------
Encryption Algorithm: AES - 256
Integrity Algorithm: SHA1
Diffie-Hellman Group for Key Exchange: 4096bit
Key Life Time(Seconds): 28800
==Phase 2==
Encryption Algorithm: AES - 256
Integrity Algorithm: SHA1
Diffie-Hellman Group for Key Exchange: 4096bit
Key Life Time(Seconds): 3600
 

  0      
  0      
#1
Options
1 Reply
Re:MR6400 V5.3
2022-09-15 10:26:28

  @KrzysztofF 

 

Hi,could you please send an email to "support.forum@tp-link.com" and provide the following information?

1. Network topology on both sites including IP addresses

2. Do both routers on two sites MR6400 V5.30? and were they both on 3G/4G Router mode?

3. Screenshots of the IPSec VPN Settings and Advanced->Status page both both routers

4. The IPSec VPN status is always down on the MR6400, right?

Nice to Meet You in Our TP-Link Community. Check Out the Latest Posts: Archer GE550 - BE9300 Tri-Band Wi-Fi 7 Gaming Router EasyMesh Is Available When Wi-Fi Routers Work in AP Mode as A Controller. Archer BE550 New Software Enhances System Stability and Optimizes MLO Network Stability. TL-WA3001 Supports EasyMesh, Speed Limit, Guest Network in AP Mode and/or Multi-SSID Mode. If you found the post or response helpful, please click Helpful. If an answer solves your problem, click "Recommended Solution" so that others can benefit from it.
  0  
  0  
#2
Options