2.4Ghz stops working in Tp-Link Archer C6U
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Hello Team,
I am experiencing connection drops on 2.4Ghz, it's not even showing in the devices. Previously also I faced the same issue and I connected to a service center engineer over a call, he recommended some settings which I did, after it starts working but after 2 days again the same issue I started facing. The firmware is also up to date, channel number is 11 and channel width is 40MHz. Please help me to resolve this issue ASAP.
Thanks,
Monis
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
Hello @Monis
Thank you for reaching out to us and welcome to the TP-Link community.
Do you mean the 2.4G signal may disappear when it stops working? Only the 2.4G connection drops, wired and 5G connection are good? If that is the case, it's suggested to review the wireless networks around you via a Wi-Fi analyzer and try to choose one with less interference with others, then monitor the connectivity. You may follow this FAQ to troubleshoot further.
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
If that is the case, I assume the wireless 2.4G might be broken, please continue discussing this with the local tech support to be advised further.
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
Yes, it's suggested to be advised further by the local tech support and take further actions.
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 528
Replies: 5
Voters 0
No one has voted for it yet.