4G+ Cat6 AC1200 Wireless Download speeds slow

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

4G+ Cat6 AC1200 Wireless Download speeds slow

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
4G+ Cat6 AC1200 Wireless Download speeds slow
4G+ Cat6 AC1200 Wireless Download speeds slow
2022-03-01 08:07:19 - last edited 2022-03-02 01:38:35
Model: Archer MR600  
Hardware Version: V2
Firmware Version: 1.3.0 0.9.1 v0001.0 Build 210208 Rel.61056n

I have been using this router for four months now, still with the same SIM card and the same spot on my desk. When I first started using it I was getting 20ms ping, 75.63Mbps down and 40.51Mb/s up however, now I am getting 17ms ping, 7.0-9.5Mbps down, and 41-43Mbps up. I do occasionally lose internet connection as well, but that happens maybe once every two hours. The signal strength hasn't changed as it is still sitting at 75% on the routers status page.

 

 

For my connection to the router, I am using a cat5e cable between the router and my laptop and have Wi-Fi disabled.

 

I also tried "Enabling IGMP Snooping in the Advanced tab under Network/LAN Settings"  from this forum post however I haven't noticed any performance changes.

 

Any additional suggestions would be greatly appreciated.

  1      
  1      
#1
Options
1 Reply
Re:4G+ Cat6 AC1200 Wireless Download speeds slow
2022-03-02 12:51:39

  @Rudox 

Hi, did you notice any change in the 4G band since I see now it is band 1? maybe another 4G band will help provide a better bandwidth?

Would a reboot or factory reset of the model help a little bit?

Have you tried to take out the SIM card and put it into the smartphone, then test the speed on the smartphone?--please also check whether the smartphone is working on band 1 as well.

--After that, please enable the mobile hotspot and test the wireless speed of the hotspot on a different mobile device?

Thank you very much and wait for your reply.

  0  
  0  
#2
Options