Home Network Community > Wi-Fi Routers > Wlan red light
< Wi-Fi Routers

Wlan red light

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Wlan red light

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Wlan red light
Wlan red light
2021-11-23 10:33:11 - last edited 2021-11-25 06:40:18
Model: Archer C80  
Hardware Version: V1
Firmware Version:

Hello, after a long time i needed to replace old router which is old TP link WR841N because i had problem with coverage and constant dissconecting. Ive bough Archer c80 but when connected all the cables the router works but it doeant have access to internet and the WLAN diode is red. I dont know what to do. Reset did nothing. When i hooked up the old router it works fine. What do i do?

  0      
 
  0      
 
#1
Options
1 Accepted Solution
Re:Wlan red light-Solution
2021-11-23 15:40:20 - last edited 2021-11-25 06:40:18

@terziyski 

Thank you very much, everything works now. I just took the MAC adress from the old router settings and replaced default MAC adress of the new router, to the MAC adress of the old router and everything is working now. The cloning did not help. But everything works now. Thank you very much.    :) 

Recommended Solution
  0  
  0  
#3
Options
2 Reply
Re:Wlan red light
2021-11-23 13:47:22

@Samujel 

 

 

Here's your C80 LED status description.

If you don't have any ISP provided device before your wireless router then probably you need to clone the 841N MAC address to your new C80.

Here's an example video on how to install your wireless router for the first time.

 

If this was helpful click on the arrow pointing upward to make it blue. If this solves your issue, click the star to make it blue and mark the post as a "Recommended Solution".
  1  
  1  
#2
Options
Re:Wlan red light-Solution
2021-11-23 15:40:20 - last edited 2021-11-25 06:40:18

@terziyski 

Thank you very much, everything works now. I just took the MAC adress from the old router settings and replaced default MAC adress of the new router, to the MAC adress of the old router and everything is working now. The cloning did not help. But everything works now. Thank you very much.    :) 

Recommended Solution
  0  
  0  
#3
Options

Information

Helpful: 0

Views: 1034

Replies: 2

Related Articles
 Archer C80 Red Light
1591 0
Solid red light
2648 0
Red light internet
929 0
 The router suddenly shows a red light
3125 0
deco S4 red light
1089 0
Red Light after power outage
14385 4
About Us
Press
Copyright © TP-Link Systems Inc. All rights reserved.