Home Network Community > Wi-Fi Routers > TP-Link Router as Access Point or repeater
< Wi-Fi Routers

TP-Link Router as Access Point or repeater

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

TP-Link Router as Access Point or repeater

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
TP-Link Router as Access Point or repeater
TP-Link Router as Access Point or repeater
2021-11-23 06:13:34 - last edited 2021-11-24 09:35:15
Model: Archer VR600  
Hardware Version: V2
Firmware Version:

Hi there

 

I am very new to this networking world and there are a lot of things that I don't understand.

 

I need some assistance from you to help me setup a modem router Archer VR600  v2 as access point of repeater. I am not sure what information I should share here. But, my root router is DIR-830M AC1200 and the default gateway is 192.168.1.1. I've tried to configure the Archer as wireless router but the internet always showing disconnected. Able to connect to my SSID but without internet connection. Please guide me. Thank you.

  0      
 
  0      
 
#1
Options
4 Reply
Re:TP-Link Router as Access Point or repeater
2021-11-24 18:51:39

@Sunny1978 

 

When VR600 is configured as wireless router use it's LAN4/WAN port to connect to DIR-830M LAN port (VR600 WAN Settings - Dynamic IP):

 

If this was helpful click on the arrow pointing upward to make it blue. If this solves your issue, click the star to make it blue and mark the post as a "Recommended Solution".
  1  
  1  
#2
Options
Re:TP-Link Router as Access Point or repeater
2021-11-25 14:36:58

@terziyski Thank you Sir. I will try this option and see. rgds

  1  
  1  
#3
Options
Re:TP-Link Router as Access Point or repeater
2021-11-26 03:56:05
I tried as per your advice but still not able to access the internet. I wonder if the SSID must carry the same name as in the root router. For your information, after setting the operation mode to Wireless router, I disabled the DHCP and change the IP address in this second router. Hope you will be able to guide me further. Thank you.
  0  
  0  
#4
Options
Re:TP-Link Router as Access Point or repeater
2021-11-26 05:10:54

@Sunny1978 

 

Login VR600, set its LAN IP address to 192.168.0.1, enable its DHCP server (192.168.0.100-192.168.0.199) and reboot it.

Its SSID should be different than your main router so you'd know at any time to which router you've been connected.

If this was helpful click on the arrow pointing upward to make it blue. If this solves your issue, click the star to make it blue and mark the post as a "Recommended Solution".
  4  
  4  
#5
Options

Information

Helpful: 0

Views: 1967

Replies: 4

Related Articles
Problem Access point Tp link
1221 0
Internet access lost on repeater router when activating "Access Control" on TP Link main Router
685 0
Access Point has lower speed when I connect it to my tp-link router
454 0
 How to connect a TP-Link router as an access point
858 0
I can't downgrade my tp link access point
931 0
Router to Access Point
597 0
About Us
Press
Copyright © TP-Link Systems Inc. All rights reserved.