TL-WR702N Client Mode with a L2 switch
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
TL-WR702N Client Mode with a L2 switch
Region : UnitedKingdom
Model : TL-WR740N
Hardware Version : V4
Firmware Version :
ISP :
Hi All,
I work in networking i have a customer who uses a 4g wifi router with no ethernet ports, however they now want a LAN. They do not wish to purchase a 4g router at the moment but they do have a TL-WR702N unused in their office.
Now a question i have is the 4G router gives out a dhcp range of 192.168.0.x /24 if i connect the TL-WR702N in Client mode and plug the TL-WR702N ethernet port into a 12 port switch will all users connected to the switch get an IP? or does client mode on get 1 IP address ?
Thanks
Ben
Model : TL-WR740N
Hardware Version : V4
Firmware Version :
ISP :
Hi All,
I work in networking i have a customer who uses a 4g wifi router with no ethernet ports, however they now want a LAN. They do not wish to purchase a 4g router at the moment but they do have a TL-WR702N unused in their office.
Now a question i have is the 4G router gives out a dhcp range of 192.168.0.x /24 if i connect the TL-WR702N in Client mode and plug the TL-WR702N ethernet port into a 12 port switch will all users connected to the switch get an IP? or does client mode on get 1 IP address ?
Thanks
Ben