TPLin WR1042N doesn't work on 811n
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
TPLin WR1042N doesn't work on 811n
Region : Colombia
Model : TL-WR1042ND
Hardware Version : V1
Firmware Version : 3.15.4 Build 130117 Rel.65891n
ISP :
After many hors fighting with this router and the technical support that never respond, I came to a conclusion that this router cannot work reliable with WPA2 encryption. When I use WPA2 the router looses the administration capabilities and it doesn't respond to http requests. It responds to pings though, but is very erratically taking in average 800ms to get the ping back and more or less 45% of packets losts. Remember this router is in my local network.
If I change the router to work with WEP encryption it works with no problems but as the instructions says, 'WEP is not supported in the 811n standard so I bought an 300N router and I'm getting a very expensive 54g router.
Please TPLink, work on updating this firmware. I trusted your brand but I'm a lot dissapointed.
Has anyone had the same problem? Please post if you find this solution helpfull.
Model : TL-WR1042ND
Hardware Version : V1
Firmware Version : 3.15.4 Build 130117 Rel.65891n
ISP :
After many hors fighting with this router and the technical support that never respond, I came to a conclusion that this router cannot work reliable with WPA2 encryption. When I use WPA2 the router looses the administration capabilities and it doesn't respond to http requests. It responds to pings though, but is very erratically taking in average 800ms to get the ping back and more or less 45% of packets losts. Remember this router is in my local network.
If I change the router to work with WEP encryption it works with no problems but as the instructions says, 'WEP is not supported in the 811n standard so I bought an 300N router and I'm getting a very expensive 54g router.
Please TPLink, work on updating this firmware. I trusted your brand but I'm a lot dissapointed.
Has anyone had the same problem? Please post if you find this solution helpfull.