Home Network Community > Wi-Fi Routers > after hard reset the power led on and turns off in 10sec not able to understand why this happening
< Wi-Fi Routers

after hard reset the power led on and turns off in 10sec not able to understand why this happening

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

after hard reset the power led on and turns off in 10sec not able to understand why this happening

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
after hard reset the power led on and turns off in 10sec not able to understand why this happening
after hard reset the power led on and turns off in 10sec not able to understand why this happening
2021-08-20 17:59:26
Model: Archer C50  
Hardware Version: V6
Firmware Version: 2.0

i have just reset the router using a pin and hold it till 10sec then reset happend and after that i just power off and turn on the router but 

the router power led gets on and after few seconds it goes back off.

not able to see the admin page via lancable and not able to see any wifi signal as well .

 

i dont understand why this happen as in past also i have done the same procedure.

 

  0      
 
  0      
 
#1
Options
3 Reply
Re:after hard reset the power led on and turns off in 10sec not able to understand why this happening
2021-08-20 20:17:10

@VivekPanchal 

 

Hi,

 

How soon after triggering the factory reset did you power the router off? I mean, was it like within a couple of seconds or did you give the router reasonable time to complete its factory reset process?

 

Have you tried to perform the factory reset a second time? Make sure you give it a bit of time (preferably until it has fully booted up) before you power it off.

  0  
  0  
#2
Options
Re:after hard reset the power led on and turns off in 10sec not able to understand why this happening
2021-08-21 05:06:06
i mean i did give it full time to reset then i turned off the router to fix the cables and all after that this thing started happening. now i cant even reset because the power turning off within a few seconds.
  0  
  0  
#3
Options
Re:after hard reset the power led on and turns off in 10sec not able to understand why this happening
2021-08-21 13:08:13

@VivekPanchal 

 

I see. Since the router still booted up after the factory reset, but was dead after the power cycle, then maybe the failure is actually unrelated to factory reset and something else coincidentally broke around that time.

  0  
  0  
#4
Options

Information

Helpful: 0

Views: 752

Replies: 3

Related Articles
Super hard router reset
1488 1
Hard reset on range extender
842 0
Can't hard reset extender in bootloop
958 1
After factory reset range extender power led light does not stop blinking
514 1
 Hard Reset TL-WDR3600
1421 0
 WR541G Won't hard reset
696 0
About Us
Press
Copyright © TP-Link Systems Inc. All rights reserved.