Change of ISP can’t get my extender to recognise the new one
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Change of ISP can’t get my extender to recognise the new one
I recently changed my ISP and have a new router. I have tried a hard reset on the wireless adapter and have also connected it directly to the new router via Ethernet. Yet when I try to connect it still shows the name of my old router and will not accept the password of the new one.
how can I get it to recognise my new router
Re:Change of ISP can’t get my extender to recognise the new one
Reset the extender to factory defaults:
Then go to Chapter 2 of your user guide to reconfigure the extender from scratch, connecting it to the new router.
Ethernet port is used when you configure the device in AP mode or as a wireless adapter.
If this was helpful click on the arrow pointing upward to make it blue.
If this solves your issue, click the star to make it blue and mark the post as a "Recommended Solution".