Accepted [Wi-Fi Routers] AP Mode supports Onemesh
Updated on Sep 2, 2024:
We're thrilled to announce the rollout of new official firmware rolling out for multiple routers, including the BE, AX, and AC series, which introduces EasyMesh in AP Mode as a Controller. Check the following thread for a list of the models that support this feature:
EasyMesh Is Available When Wi-Fi Routers Work in AP Mode as A Controller
-----------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------
There are some cases that customers have their main modem router acting as the gateway and DHCP server in the network, and thus they need to change the TP-Link router to work as an Access Point to avoid the double-NAT issue. However, some of them still request the Onemesh routers (TP-Link OneMesh Devices) to support building up an Onemesh system with the Onemesh extenders when working in Access Point mode.
Before requesting that, we hope you could have a brief understanding about the difference between Router mode and Access Mode by referring to the article below, some advanced features would not be supported in Access Point mode, which is also the case for Onemesh:
If you do purchase an Onemesh router and extender already, you will need to configure it in Router mode to build up the Onemesh system. For better performance, it is suggested to check with your modem router support that if you can turn it into bridge mode or pure modem, then configure the TP-Link router as the main router.
However, we still open our ears for the market and customers here that how many of you request the Onemesh router supporting Onemesh in AP mode, and all of your opinions will be passed to the relevant team to be considered.
Press the like button and/or leave your comments and opinions if you also request the same. You can also exchange or share your opinions on this feature here. Thanks!
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
In my case I have a MR600, a Archer C6 and a RE300. Modem and Router are connected via cable. OneMesh only works if the C6 is in router mode. In AP mode it isn't working. So it is not possible to have all devices in one network with the same subnet (e.g. 192.168.0.x and 255.255.255.0). EasyMesh is nice but not really a satisfying solution. If I want to use it I have to buy new devices because the majority of my devices are not supported. This is not very sustainable. Please consider to implement OneMesh for Routers in AP mode.
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
Information
Helpful: 197
Views: 36723
Replies: 105