MR600 V2 Carrier Aggregation Issue
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
I am using MR600 V2 with jio sim in India.
B3 + B5 is working.
B40 + B40 is also working, which is good.
B3/B5 + B40 is not working. For that case only giving priority to B40 and it is working as B40 + B40. If the B40 is down or poor signal then your internet will be die. Also when file is uploading carrier Aggregation is not working.
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
Whether the bands aggregate or not, and how these bands are aggregated with each other, are decided by the cellular tower, the router only sends the request to the cellular tower in your area.
Just to confirm, can you get band 3 / band 5 + band 40 on another 4G router, or can you get the two aggregated on the phone?
- Copy Link
- Report Inappropriate Content
After restart or band selection b3 + b40 is working for 30 to 50 seconds. After that it is permanently switching b40. That means in my area b3+b40 is working. One of youtuber also mention that mr600 v1 is working b3+b40, but V2 is not working.
- Copy Link
- Report Inappropriate Content
We have reported the issue to the support engineers, they will likely reach out to you via email to continue to troubleshoot your issue.
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 1466
Replies: 3
Voters 0
No one has voted for it yet.